Laserfiche WebLink
Cabarrus county Zoning Ordinance <br />Chapter 4- Overlay Districts and Zones <br />14. A level 2 buffer yard shall be installed around the perimeter of the <br />Manufactured Home Park (see Chapter 9 for planting requirements). <br />15. The park owner shall be responsible for the placement of the dwelling unit on <br />the designated space within the park. This responsibility assures the <br />placement of the dwelling unit adheres to the development standards listed <br />below, including setbacks from lot lines and street as stated in this ordinance. <br />A violation of any section of this section and correction thereof shall be the <br />responsibility of the park owner(s). <br />a. Interior lots shall have the building setback for principle structures <br />measured thirty feet from the edge of the pavement <br />b. Corner lots shall have the building setback for principle structures <br />measured thirty feet for the edge of the pavement of each right -of- <br />way. <br />c. Accessory structures shall not be located closer to any right -of -way <br />than the principle structure. <br />d. Accessory structures shall be placed twenty feet minimum from any <br />other dwelling unit, additions to any dwelling unit and other accessory <br />structures. <br />Inteliol Lot <br />l <br />I <br />301 <br />4Gā€¢ R.'W <br />W M111 <br />fleck <br />L <br />fleck <br />- <br />W nrin. from edge <br />- <br />of pavement <br />I <br />?U' Min <br />cluck <br />deck <br />ā‘ <br />ā‘ <br />accessory <br />acres Sol'r' <br />structure <br />01 UOUI e <br />Accessory buildings: must <br />T x0ā€¢ n tiin <br />he min from any other <br />clwelel lina ulrit or acl[li[ian. <br />deek <br />colnel Lot <br />45' R.W <br />Section 4 -&932 Design and Installation Standards for Individual <br />Manufactured Homes <br />All manufactured homes within an MH -1, MH -2 or MHP Overlay district shall comply <br />with the following design and installation standards: <br />1. Any manufactured home on an individual lot shall conform to the same <br />building setback standards, side and rear yard requirements, <br />standards for enclosures, access, vehicle parking, and square footage <br />Chapter 4 Page 32 of 34 <br />Revised 2013 <br />G - 1 <br />Attachment number 3 <br />Page 348 <br />F <br />301 <br />W M111 <br />fleck <br />fleck <br />45' P. 4'tit <br />Section 4 -&932 Design and Installation Standards for Individual <br />Manufactured Homes <br />All manufactured homes within an MH -1, MH -2 or MHP Overlay district shall comply <br />with the following design and installation standards: <br />1. Any manufactured home on an individual lot shall conform to the same <br />building setback standards, side and rear yard requirements, <br />standards for enclosures, access, vehicle parking, and square footage <br />Chapter 4 Page 32 of 34 <br />Revised 2013 <br />G - 1 <br />Attachment number 3 <br />Page 348 <br />