Laserfiche WebLink
5.6 Horizontal Roof Edge <br />The extruded roof edge structural members will measure 6" x 4.75" with a 2" radius, a minimum <br />wall thickness of .125" and an alloy rating of 6061 -T6. The roof extrusions will include an <br />integral, full - length drip rail for each side and from side to side on both the front and rear of the <br />module. <br />Does your bid comply? Yes No <br />5.7 Static Load Test <br />The ambulance body as a unit shall be designed and built to provide impact resistance. The body <br />shall be of sufficient strength to support the entire weight of the "fully" loaded vehicle on its top <br />or side if overturned, without crushing, separation of joints, or excessive deformation of roof <br />bows, reinforcements, body parts, doors, floor members, inner linings, outer panels, rub rails or <br />any other structure in accordance with AMD Standard No. 001. <br />Does your bid comply? Yes—/No <br />5.8 Drip Rails <br />In addition to the drip rail found in the roof extrusion there shall be a drip rail provided over each <br />exterior compartment door. These drip rails shall be attached in such a manner to provide quick <br />and easy replacement in the event they are damaged. They shall not be riveted, welded, or <br />integral to the doorframe extrusion. <br />Does your bid comply? Yes V I NO <br />5.9 Sub floor Structure <br />The sub floor structure of the modular body shall be constructed of 2" x 2" x .125" structural <br />tubing. There shall be two (2) longitudinal and twelve (12) lateral tubes welded together to form <br />a sub floor structure. The floor structure shall be designed to provide strength while conforming <br />to chassis component clearance requirements and to provide appropriate locations for body <br />mounting devices. Sufficient structure for maximum support and the safe installation of cot <br />mount hardware or other floor - mounted devices will be integral to the sub floor structure. The <br />sub floor structure shall include a 4" x 5" x .250" tube of 6061 -T6 alloy as an "in- frame" pass <br />through for the OEM fuel filler neck. Routing under the sub -floor frame or frame trimming to <br />accommodate the fuel fill hose is not acceptable to this agency and will not be accepted <br />Does your bid comply? Yes No <br />5.10 Body Mounting <br />The chassis manufacturer shall mount the body to the chassis frame at the ten (10) points <br />provided by the OEM chassis manufacturer. For consistency of materials, compliance with the <br />chassis manufacturer's second unit body mounting requirements and to facilitate future <br />remounting of the body; only OEM supplied mounting hardware shall be used. Methods of body <br />to chassis mounting that do not match the OEM cab mounting process will not be considered due <br />to the stresses created by difference in flexibility between the cab and the modular body. The <br />mounting hardware shall consist of ten- (10) .50" 6061 -T6 formed, offset aluminum plates <br />welded to the lateral sub floor members at points corresponding to the mounting points on the <br />OEM frame rails. Rubber mounting isolators, steel caps and Grade 8, 7/16" bolts supplied by the <br />chassis manufacturer shall comprise the balance of the mounting hardware. There shall be an <br />insulating layer of rubber for an electrolytic barrier between the dissimilar metals of the OEM <br />isolator caps and the aluminum plates welded to the sub floor frame and between the aluminum <br />plates and the steel, nut -spin prevention plate on the top of the mounting hardware. <br />Does your bid comply? YesVNo <br />Attac4ent number 1 <br />F -5 Page 119 <br />