AG 2012 02 20 - Laserfiche WebLink

Home Browse Search

protrude beyond the face of the bumper or bumper guards. The system as installed shall meet the minimum requirements of Federal Specification Does your Y bid comply? Yes No 7.0 ADDITIONAL SYSTEMS, EQUIPMENT, ACCESSORIES & SUPPLIES 7.1 S tandard Mandatory Miscellaneous E Unless otherwise precluded elsewhere in this specification, the ambulance shall be equipped with but not limited to the following: A. No Smoking Signs Two (2) "No Smoking Oxygen Equipped" signs. Does your bid comply? Yes No B. Fasten Seat Belt Suns Two (2) "Use Of Seat Belt Required" signs. Does your bid comply? Yes No C. Overhead Grab Rail Minimum 72 "L x 1.25 "D, maximum 4 inch4 -inch depth, on the ceiling over the primary patient, contour rolled at each end with no protruding sharp edges. The grab rail shall be installed and perform in accordance with AMD Standard 008 Does your bid comply? Yes No 7.2 Paint OPTIONAL — SEE OPTIONAL PRICING SECTION OF THIS BID The ambulance shall be painted in accordance with KKK- A -1822E specifications for Preparation and Painting. Only a polyurethane paint system shall be used to paint the modular . body. Both white and colored units will be painted with a base coat/clear coat system. Prior to painting, the entire module shall be carefully ground to remove all welding slag and major scratches in body surface. The module is then washed with a wax and grease remover to remove all oil, dirt and grease left over from the manufacturing process. The entire module is then sanded using a dual action sander (DA). Areas that cannot be sanded with a DA shall be hand sanded and scuffed using grit sand paper and scotch bright pads. All deep scratches, dents and low spots along with roof corners and roof seams will be body blown off and wash-primed. 11 When i the body has putty and then sanded. The body will then dried, it shall be tacked and sprayed with three wet coats of a combination of primer to total dry film build of 4.0 — 6.0 mills and bake• Pinholes will wax and greadse the entire unit remover and sanded with 220 grit. The unit will t hen be seam sealed with 3M 8360 seam sealer. The unit will be blown off, washed with wax and grease remover and tacked off. All bare metal areas will be touched up with a wash primer. Once dried the unit will again be tacked off. The unit will then receive a wet coat application of an epoxy primer /sealer, cured and coated with a PPG Delfleet paint process. Delfleet is a high solids Polyurethane Basecoat that is a fast drying low VOC basecoat /clear coat polyurethane designed to produce ultimate durability with a highly polished finish. The unit will then be baked to cure and then sanded with 1000 grit to remove imperfections, dusted off and buffed with 3M Prefect -it II System. All materials in the painting process must be rated as containing low V.O.C.'S making the process as environmentally friendly as possible. 33 Attachment number 1 F -5 Page 130