Laserfiche WebLink
<br /> <br /> <br /> <br />" <br /> <br /> <br /> <br />.. <br /> <br />-0 <br /> <br /> <br /> <br />. <br />'~" <br />,~, <br /> <br />" <br /> <br /> <br />" <br /> <br /> <br />F-IO <br /> <br />. <br /> <br />REV. ALTERATIONS DATE BY <br />1 VALID 11-20-00 JGV <br />2 REPLACED 4215-327 VlTH 4215-374 - 1-7-04 CMC <br /> <br />See sheet 215 x 374 for base assembly. <br /> <br />Set the Bases on the ground with the rectangular <br />tubes pointing up. Set them in place where the <br />unit is to be operated <br /> <br />Insert the male end of the Bottom Right section <br />into either base and attach the latches. The <br />detector screens must be facing the middle of the <br />portal. <br /> <br />Insert the male end of the Top Right section into <br />the female end of the Bottom Right section lind <br />attach the latches. <br /> <br />Repeat the process for the LEFr side. <br /> <br />Make sure that the sensors are pointing toward <br />each other. <br /> <br />Connect the cable that goes between the two <br />bases. <br /> <br />Plug the ELECTRONICS section onto the back <br />of the Bottom Left section. First, engage the <br />black connectors. Then enSure thatthe pin on the <br />back of the Bottom Left section goes into the hole <br />on the electronics. _ Attach the latches. If you are <br />using the optional Remote Electronics Extension <br />Cable, connect one end of the cable to the Bottom <br />Left section and the other end to the Electronics. <br />Locate the electronics as desired <br /> <br />If you have line voltage available, plug the <br />POWER CORD into the connector on the bottom <br />of the electronics marlced INPUT. Ifnot, install <br />"D" Cell batteries into the battery compartment. <br /> <br />Turn on the POWER switch. <br /> <br />