AG 2005 05 23 - Laserfiche WebLink

Home Browse Search

All manufactured homes within an MH-l, MH-2 or MHP Overlay district shall comply with the following design and installation standards: 1. Any manufactured home on an individual lot shall conform to the same building setback standards, side and rear yard requirements, standards for enclosures, access, vehicle parking, and square footage standards and requirements to which a conventional single-family residential dwelling on the same lot would be subject. This provision shall not apply to a Manufactured Home Park where the lots are not subdivided into separate tracts of land. (Refer to # 14 above for placement standards.) 2. A minimum 3:12 roof pitch is required for all Type I units. Type II units are not required a minimum roof pitch. 3. A continuous masonry curtain wall or foundation, unpierced except for ventilation and access, shall be installed under the outer perimeter of the Dwelling from its base to the ground so as to be compatible with surrounding residential land uses. (Note: See APPENDIX C, Section C-503, Volume VII, North Carolina State Building Code). A masonry curtain wall shall not be required for installations in a Manufactured Home Park or in the AO zoning district, in those cases other compatible materials may be used. 4. The Dwelling shall be attached to a permanent foundation system in compliance with the N.C. State Building Code as may be amended, and the following requirements: 5. All wheels, axles, transporting lights and removable towing apparatus shall be permanently removed prior to installation of the dwelling unit. Hitches may remain, but shall be screened from view unless located within a manufactured home park. 6. For homes which are narrower than seventeen (17) feet in width, the unit shall be oriented on the lot so that its long axis is parallel to the street. G-1