Laserfiche WebLink
<br />a. Interior lots shall have the building setback for principle structures measured <br />thirty feet from the edge of the pavement <br />b. Corner lots shall have the building setback for principle structures measured <br />thirty feet for the edge of the pavement of each right-of-way. <br />c. Accessory structures shall not be located closer to any right-of-way than the <br />principle structure. <br />d. Accessory structures shall be placed twenty feet minimum from any other <br />dwelling unit, additions to any dwelling unit and other accessory structures. <br /> <br />D <br /> <br />D <br /> <br /> Corner Lot <br /> - - 4(;' RiW - - <br />-3o'MinI~ I r- I WMin- <br /> 1--1 I 1--1 1 I <br />I IWMill 30"Min <br />L......I L......I <br /> deck deck <br /> r- 46' RtW-.l <br /> I I <br /> <br />Interior Lot <br /> <br />1 <br /> <br />4Jj'RW -- <br /> <br />30' min. from edge of p~lVemellt I ~ <br /> <br />I ~~n I <br /> <br />L......I <br />deck <br /> <br />-I <br />1 <br /> <br />L......I <br />deck <br /> <br />accessory <br />structure <br /> <br />accessory <br />8truc1:UI"e <br /> <br />Accessory buildings must <br />be 20' mln from any other <br />dwelling unit or addition. <br /> <br />T 20' min <br /> <br />L......I <br />deck <br /> <br />Section 4-51. Design and Installation Standards for Individual Manufactured HomeS. <br /> <br />All manufactured homes within an MH-1, MH-2 or MHP Overlay district shall comply with <br />the following design and installation standards: <br /> <br />1. Any manufactured home on an individual lot shall conform to the same building setback <br />standards, side and rear yard requirements, standards for enclosures, access, vehicle parking, <br />and square footage standards and requirements to which a conventional single-family <br />residential dwelling on the same lot would be subject. This provision shall not apply to a <br />Manufactured Home Park where the lots are not subdivided into separate tracts of land. (Refer <br />to #15 above for placement standards.) <br /> <br />. <br /> <br />2. A minimum 3: 12 roof pitch is required for all Type I units. Type II units are not <br />required a minimum roof pitch. <br /> <br />3. A continuous masonry curtain wall or foundation, unpierced except for ventilation and <br />access, shall be installed under the outer perimeter of the Dwelling from its base to the ground <br />so as to be compatible with surrounding residential land uses. (Note: See APPENDIX C, <br />Section C-503, Volume VII, North Carolina State Building Code). A masonry.curtain wall shall <br />not be required for installations in a Manufactured Home Park or in the AO zoning district, in <br />those cases other compatible materials may be used. <br /> <br />-7- <br />k~-I (~J <br />