AG 2013 03 18 - Laserfiche WebLink

Home Browse Search

Driver's Compartment Controls The Front Control Switch Panel shall incorporate low- voltage full size easy -to -use rocker switches. Switches are for ambulance equipment operation, including, but not limited to the following: siren, all warning and emergency lights, battery indicator lights, horn /siren cut -off switch, silent signal intercom, side and rear flood lights, compartment and entry door ajar warning light, patient compartment master switch, emergency lights master switch, voltmeter, ammeter and air conditioner /heater master switch. The control console shall be connected to the electronic control module by a computer cable with parallel type connectors for easy, safe, positive connections. The control console shall not be integrated into the OEM dash but will be fabricated, and located between the drivers and passenger's seats. This console shall have cup holders, with areas for radios and map books. The control console's gauges shall be internally illuminated and controlled by the headlight switch rheostat function. Does your bid comply? Yes _X_ No Warning Indicators The electrical system shall incorporate a warning light panel located in the front control switch panel. It shall provide indicator lights showing patient entry doors, either side or rear, are open and shall flash a RED light behind lettering etched into the control panel stating'ENTRY OPEN'. There shall also be an exterior compartment 'door open' warning light that shall flash an AMBER light behind lettering etched into the control panel stating'COMPT. OPEN'. Both systems will incorporate an audible alarm if a door is open and the parking brake is not activated. The etched letters shall be 1/8" high with a 5/8" x 5/8" etched outline around the lettering, both will light when activated. Does your bid comply? Yes _X_ No Back -Up Alarm The vehicle shall have an Ecco model #EC520 solid -state back -up alarm rated at 97 decibels and equipped with a cancel button located on the front control switch panel, which will deactivate the alarm. The alarm shall be an automatically resetting type whereby the alarm is reactivated automatically each time the vehicle is placed in reverse gear. The purchaser acknowledges and accepts that the provision for back -up alarm cut -off switch may be in non - compliance with motor vehicle regulations in certain States. Does your bid comply? Yes _X_ No 25 Attachment number 1 F -2 Page 73