Laserfiche WebLink
Ammeter <br />The electrical system shall incorporate an LED (digital) ammeter, which is capable of indicating a current of 200 <br />amperes and shows the total amp draw of the conversion system on the dual batteries. The ammeter shall <br />incorporate an external shunt, which does not exceed 50 mill volts at maximum current. The ammeter and <br />shunt shall have a combined accuracy of approximately 10 percent of the full -scale reading. The ammeter shall <br />be located in the driver's control console. The shunt shall be protected against physical damage, weather and <br />road spray and shall be mounted in an easily accessible location that shall minimize the length of the power <br />cables. <br />Does your bid comply? Yes _X_ No <br />Voltmeter <br />The vehicle shall be equipped with an LED (digital) voltmeter to monitor total system voltage. The voltmeter <br />connection shall be direct to eliminate erroneous readings from connection voltage drops. The voltmeter shall <br />have a minimum accuracy of +/- 5 %. The voltmeter shall be mounted in the front control switch panel. <br />Does your bid comply? Yes _X_ No <br />Module Disconnect Switch <br />This switch shall be located on the front control switch panel and shall disconnect all patient compartment <br />conversion circuits. The switch shall be connected to the electronic control module through a computer cable. <br />The switch label shall be back lighted, permanently identifying it as to function and have a green LED indicator <br />to show that function is activated. This switch shall be different than other switches on the console, with a <br />paddle handle and be red in color. <br />Does your bid comply? Yes _X_ No <br />Emergency Lights Master Switch <br />The emergency lights "master" switch shall be a paddle type switch having a translucent label with a RED "on" <br />indicator. The remainder of the function switches shall be low voltage switches. The switch shall be connected <br />to the electronic control module through a computer cable. All switch labels shall be back lighted, <br />permanently identifying it as to function and have an LED indicator to show what function is activated. <br />26 <br />Attachment number 1 <br />F -2 Page 74 <br />