AG 2013 03 18 - Laserfiche WebLink

Home Browse Search

Does your bid comply? Yes _X_ No Body Trim The following fixtures shall be added to the module shell for body protection and enhanced appearance. All items to be constructed of a minimum .100" thick bright polished aluminum tread plate with a minimum alloy property of #3003. All diamond plate trim shall be attached with 3/16" aluminum rivets and shall consist of the following: (A). Radius formed diamond -plate corner guards on all four corners with a minimum height of 10 inches. (B). Aluminum diamond plate rails shall be installed at the bottom edge on each side of the body. Rub rails are to be bolted on the 2" x 3" aluminum extruded tubes for ease of replacement and shall be spaced away from body .125" to prevent forming a dirt trap. (C). A diamond -plate liner shall fully encase all sides and bottom of the side step entrance well. Corner seams of this liner shall be MIG or TIG welded to insure a watertight, flushable -type stepwell. (D). A full width rear diamond -plate kick plate shall be installed from the rear step to the bottom of the rear doors. (E). An aluminum open grip strut step with individual diamond -plate end caps shall be installed at the rear loading doors. Step to be non - flexing and shall pivot upward by means of a full width stainless steel hinge. Rear bumpers without the center flip up section are not acceptable. End cap pod framework to be constructed of 2" x 3" steel closed tube, corner braced and welded to chassis frame. Bumper shall not exceed 9" from front to rear, and must not be mounted flush against the kick plate. (F). An aluminum polished fender shall be installed at each modular wheel well opening. The flare shall provide additional body protection and shall be installed in such a manner as not to rub the rear tires. (G). Extruded drip rails shall be installed above all exterior compartments. These drip rails shall be attached in such a manner to provide quick and easy replacement. They shall not be riveted, welded, or an integral part of the door frame extrusion. (H). A recessed polished cast aluminum fill guard shall be installed at the gas fill opening in the street side of the module. There shall be a stainless steel drip panel below. (1). To reduce the probability of corrosion and oxidation around the trim mounting points, each mounting area will be treated with ECK. Does your bid comply with lines "A" through "I "? Yes _X_ No 48 Attachment number 1 F -2 Page 96