Laserfiche WebLink
Dimensions given here are applicable to the Type III ambulance. For the Type I, the dimensions may be altered <br />as required to accommodate the chassis differences, but must be as near as possible to the requested <br />dimensions. <br />Street side Compartments (three (3) total): <br />1- 02 compartment location front 20 % "W x 80 "H x 18 VD. There shall be a vent with a cast cover located on <br />the door. There shall be a Zico electric oxygen cylinder lift installed inside. <br />2 — In front of rear wheel well 38" W x 36 %" H x 18 W D; one (1) adjustable shelf shall be installed. <br />4 — Rear compartment 28" W x 36 "H x 18 VD. There shall be one (1) adjustable shelf installed. <br />Curb side Compartments (four (4) total): <br />5 - Back board compartment at the rear, 16 "W x 80 %"H x 20 "D with one (1) fixed vertical divider extending <br />downward from the ceiling 37 ", located 8 %" from the front of the compartment. There shall be one (1) fixed <br />shelf with %" lip extending from the front of the compartment to the vertical divider. <br />6 - Next to backboard compartment behind rear wheel 19 "W x 24 %"H x 18 W D. <br />8 — ALS compartment outside dimensions 22 % "W x 57 % "H x 32 % "D. This will have inside /outside access. In <br />the center there shall be a drawer the full width of the cabinet and approximately 9" deep, accessible only <br />from the inside of the module, with a locking latch. Above and below the drawer, with inside /outside access, <br />shall be 2 cabinets of approximately equal dimensions. Each shall have one (1) adjustable shelf. The openings <br />on the inside shall be covered with split hinged Plexiglas doors. <br />9 - Front below ALS compartment, 22 "W x 12H x 20 W. This compartment is to house the vehicle's batteries <br />securely mounted in a roll out tray. This compartment shall be appropriately vented to the exterior <br />underneath the truck. <br />47 <br />Attachment number 1 <br />F -2 Page 95 <br />