Laserfiche WebLink
4.2 Exhaust Modification <br />Extend tailpipe to match module width. In addition add a PLYMOVENT adapter. Exhaust pipe <br />must have 1" clearance from rub rail and come out as close to rear tire as possible to prevent <br />damaging tail pipe and hose from hanging. X Yes No <br />Does your bid comply? <br />4.3 Fuel Tank <br />Modify gas tank filler necks to fit module - Install new fuel filler hoses and copper plumbing. <br />Also modify for fuel fill location. <br />Does your bid comply? Yes No <br />5.0 EXTERIOR BODY TRIM <br />5.1 Fuel Fill <br />Provide and install one (1) new Cast Products fuel fill plate. � No <br />Does your bid comply ? --�- Y eS <br />5.2 Diamond Plate <br />Install all new exterior diamond plate "complete" on module body. Use STAINLESS STEEL <br />screws and loc -tite for attaching all diamond plate to vehicle. Install as follows; 1 new rear kick <br />plate, 4 corner guards, 2 splash guards, 2 over wheels well and all new rub rails ( upper and <br />lower). <br />Note: Rear kick plate shall be attached using "rivnuts ", no exception, this will be checked prior <br />the acceptance. Prior to installation "ECK" must be applies under all tread plat o be installed <br />Does your bid comply? Yes No <br />5.3 Rear Bumper and Step <br />Replace rear step assembly. Replace bumper tips and grip strut. Attach new bumper frame <br />securely to chassis frame using 3 bolts minimum each side. Rear grip strut step shall be <br />professionally powder coated. <br />Does your bid comply? Yes NO <br />5.4 Fenderettes <br />Remove old fenderettes prior to paint. Provide and Install new Chrome Fenderettes after paint <br />work has been performed. ECK shall be applied prior to installation. <br />Does your bid comply? Yes No <br />6.0 MODULE EXTERIOR PAINT FINISH AND LETTERING <br />6.1 Preparation <br />Prior to any paint and body work remove all hardware, hinges, handles and emergency lighting, <br />etc. Paint shall be PPG and performed by a certified PPG facility. Paint shall b warranted for <br />Seven (7) Years / Unlimited Miles. NO EXCEPTIONS. <br />Does your bid comply? Yes No <br />6.2 Surface Refinished <br />Complete and total mechanical or chemical removal of all paint, oils, and contaminants, and all <br />lettering from module surface. NO EXCEPTION. izy es Does your bid comply? No <br />44 <br />Attachment number 1 <br />F -5 Page 141 <br />