AG 2012 02 20 - Laserfiche WebLink

Home Browse Search

2.30 Mud Flans There shall be (2) two mud flaps located behind the dual rear wheels. Does your bid comply? Yes No 2.31 Buell Air Horns Buell air horns shall be installed. (1) one 10" and (1) one 12" trumpet shall be recessed into the front bumper. A Buell compressor and reservoir tank shall be included. Switch to be mounted in console area. . Does your bid comply? Yes No 3.0 ELECTRICAL SYSTEMS AND COMPONENTS 3.1 Electrical System The emergency medical vehicle's electrical system shall be equipped with, but not limited to the following: three 12 volt batteries, ignition, starting, generating, lighting, visual and audible warning systems; specified electronics equipment and devices to include control consoles located in the cab and patient compartment and other specified accessory wiring. The electrical systems and equipment shall comply with all applicable FMVSS including Federal Motor Carrier Safety Regulations (FMCSR), and shall also conform to all the applicable SAE recommended standards and practices whether or not specifically referenced in this document. Additionally, the electrical system shall meet the requirements of AMD Standard 005. All electrical and electronic components shall be selected to minimize electrical loads and levels of heat generated by those electrical components thereby not exceeding the vehicle's generating system capacity or diminish its ability to provide the required levels of electrical power. Electrical systems utilizing switching of "hot load" circuits for emergency and warning lighting shall not be accepted by this agency. All electrical system components and wiring shall be readily accessible through access panels for checking and maintenance. The cab and patient compartment consoles shall also be constructed in such a way that the switches and gauges are easily serviced. They shall be accessible through service panels. These panels will be secured in the closed position in a positive manner, yet can be easily opened for service. Does your bid comply? Yes No 3.2 Electrical Load Warning In compliance with KKK -A -1822 E, manufacturer will not install warning lights beyond those required by this specification. Additional lighting will utilize reserve alternator capacity and could result in overloaded electrical systems, which DLay result in electrical system fa' ure and cause the ambulance to fail in the field. Does your bid comply? Yes No 3.3 Key Activated Battery Disconnect Battery disconnect shall be wired through a Commanded. Does our bid comply? Yes ®O No. Y 3.4 Battery System The vehicle shall be supplied with a three 12 -volt battery system. The batteries will have a combined minimum cold cranking ampere capacity of 2250 CCA. All three of the batteries will be mounted on a heavy -duty slide out tray located in a separate compartment below the ALS cabinet. Does your bid comply? Yes__�./No AttJ;ent number 1 F -5 Page 109