AG 2012 02 20 - Laserfiche WebLink

Home Browse Search

3.5 Battery Indicator: Two (2) battery indicator lights shall be provided. They shall be GREEN lights with a surface area equal to approximately 1/2 inch. When the vehicle ignition switch is in the "ON" position these lights shall indicate batteries are "on line" and powering the system. Does your bid comply? Yes / No - 3.6 Driver's Compartment Controls The Front Control Switch Panel shall incorporate low- voltage full size easy -to -use rocker switches. Switches are for ambulance equipment operation, including, but not limited to the following: siren, all warning and emergency lights, battery indicator lights, horn /siren cut -off switch, side and rear flood lights, compartment and entry door ajar warning light, patient compartment master switch, emergency lights master switch, voltmeter, ammeter and air conditioner /heater master switch. The control console shall be connected to the electronic control module by a computer cable. The control console shall not be integrated into the OEM dash but will be mounted to the front engine cover by means of the Powder Coated Aluminum "add on" console described in section 2.21. The control console's gauges shall be internally illuminated and controlled by the headlight switch rheostat function. There shall be a minimum of three (3) blank switches provided for customer - specified options or future use. Does your bid comply? Yes A o 3.7 Warning Indicators The electrical system shall incorporate a warning light panel located in the front control switch panel. It shall provide indicator lights showing patient compartment door(s), side and /or rear are open and shall be a flashing RED light approximately 1/2" in diameter. There shall be an exterior compartment "door open" warning light and shall be a flashing AMBER light approximately 1/2" in diameter. Does your bid comply? Yes �,/No 3.8 Back -Up Alarm The vehicle shall have a solid -state back -up alarm of at least 97 decibels equipped. The alarm shall be an automatically resetting type whereby the alarm is reactivated automatically each time the vehicle is placed in reverse gear. The purchaser acknowledges and accepts that the provision for back -up alarm cut -off switch may be in non - compliance with motor vehicle regulations in certain States. Does your bid comply? Yes No 3.9 Ammeter The electrical system shall incorporate an LED (digital) ammeter, which is capable of indicating a current of 200 amperes and shows the total amp draw of the system on the three batteries. The ammeter shall incorporate an external shunt, which does not exceed 50 millivolts at maximum current. The ammeter and shunt shall have a combined accuracy of approximately 10 percent of the full -scale reading. The ammeter shall be located in the driver's control console. The shunt shall be protected against physical damage, weather and road spray and shall be mown ed in an easily accessible location which shall minimize the length of the power cables. Does your bid comply? Yes No 3.10 Voltmeter The vehicle shall be equipped with an LED (digital) voltmeter to monitor total system voltaize The voltmeter connection shall be direct to eliminate erroneous readings from connection voltage 13 Attachment number 1 F -5 Page 110