AG 2012 02 20 - Laserfiche WebLink

Home Browse Search

drops. The voltmeter shall have a minimum accuracy of +/- 5 0 10. The voltmeter shall be mounted in the front control switch panel. Does your bid comply? YesNo 3.11 Module Disconnect Switch This switch shall be located on the front control switch panel and shall disconnect all patient compartment conversion circuits. The switch shall be connected to the electronic control module through a computer cable. The switch label shall be back lighted, permanently identifying it as to function and have an LED indicator to show that function is activated. Does your bid comply? Yes N0 3.12 Emergency Lights Master Switch The emergency lights "master" switch shall be a paddle type switch having a translucent label with a RED "on" indicator. The remainder of the function switches shall be low voltage switches. The switch shall be connected to the electronic control module through a computer cable. All switch labels shall be back lighted, permanently identifying it as to function and have an LED indicator to show what function is activated as required by KKK-A- 1822E. Does your bid comply? Yes No 3.13 Backlighting Backlighting for the front control switch panel shall turn on with the headlights and :7NO ntrolled by the headlight switch rheostat function. Does your bid comply? Yes 3.14 Exterior Lamps All exterior housings for lamps, electrical devices and fixtures shall be corrosion resistant and weatherproofed. Electrical fixtures attached to the sides of the ambulance below the 75 inch level shall be near flush mounted, not to protrude more than two (2) inches. Does your bid comply? Yes No 3.15 Radio Interference Protection All electronic devices and equipment installed which produce RFI, shall have the proper filters, suppressers or shielding to prevent electromagnetic radiation and the resultant interference to radios and other medical electronics as required by KKK- A- 1822E. There shall be (2) Radio pre wires with grounds and 2 20 AMP breakers installed. Does your bid comply? Yes No 3.16 Wiring Installation The ambulance body and accessory electrical equipment shall be served by circuit(s) separate and distinct from the vehicle chassis circuits. All power wiring provided by the ambulance manufacturer shall be copper and conform to all the SAE J1292 requirements and shall have type GXL or SXL high temperature thermoplastic or better insulation rated to 125 degrees centigrade and conforming to SAE J 1127 and J 1128. Insulation on the low- voltage computer -type control cables shall have a minimum temperature rating of eighty (80 C.) degrees centigrade. / Does your bid comply? Yes ,/ No 3.17 Wiring Labeling The wiring shall be permanently color - coded, Ink Jet Dyed with the function the wire serves. These functions shall be embossed at a minimum of 4" intervals the entire length of th wire. Does your bid comply? Yes No 14 Attachment number 1 F -5 Page 111