AG 1996 03 07 - Laserfiche WebLink

Home Browse Search

26. CENTER WALL IN EACH RUN IS TO HAVE AN OPENING OF APPROX. 24w X 30h WITH GUILLOTINE TYPE DOOR TO ALLOW ANIMALS TO MOVE FROM INTERIOR SECTION OF RUN TO EXTERIOR SECTION. THE DOOR WILL BE EQUIPPED WITH A STEEL CABLE AND PULLEY MECHANISM TO ALLOW OPENING AND CLOSING FROM THE EXTERIOR WALKWAY. 27. ENTRANCE DOORS ARE TO BE SOLID CORE METAL CLAD DOORS WITH DOUBLE DEAD BOLT LOCKS. DOORS ARE TO BE EQUIPPED WITH SELF CLOSING MECHANISMS WHICH ALLOW THE DOORS TO BE POSITIONED IN AN OPEN POSITION. 28. INTERIOR DOORS IN HALL ARE TO BE OF ALUMINUM CONSTRUCTION WITH WINDOW IN EACH DOOR AT HEAD HEIGHT. THESE DOORS WILL BE SWINGING DOORS WITH RUBBER SEALS AT TOP, BOTTOM AND MIDDLE. A MECHANISM WILL BE PROVIDED TO POSITION THESE DOORS IN THE OPEN POSITION FOR CLEAN UP AND VENTILATION. 29. EACH RUN IS TO BE EQUIPPED WITH GATES ON THE INTERIOR AND EXTERIOR ENTRANCES TO EACH RUN. THE EXTERIOR GATES WILL BE EQUIPPED WITH A MECHANISM FOR THE PADLOCKING OF THE GATE. 30. ALL ENCLOSED ROOMS WILL HAVE FLOOR DRAINS AT CENTER WITH PROPER SLOPE OF FLOOR TO PROVIDE ADEQUATE DRAINAGE. 31. ACCESS TO HOT WATER TO BE PROVIDED AT TWO (2) LOCATIONS IN INSIDE HALLWAY AND TWO LOCATIONS ON OUTSIDE ALONG SOUTH SIDE OF BUILDING AND ONE (1) LOCATION IN THE CENTER OF THE NORTHERN OUTSIDE AREA. THE HOT WATER SYSTEM SHALL BE EQUIPPED WITH A TEMPERATURE CONTROL MECHANISM AT THE LOCATION WHERE IT COMES OFF THE HOT WATER HEATER. FREEZE PROTECTION FAUCETS SHALL BE PROVIDED. (SEE FLOOR PLAN FOR SUGGESTED LOCATIONS OF HOT WATER ACCESS). HEAT WILL BE PROVIDED FOR INTERIOR OF SHELTER AREA BY MOST ECONOMICAL MEANS POSSIBLE AFTER CONSIDERING THE TYPE AREA BEING SERVED. (IF HEATING METHOD PRECLUDES FORCED AIR AND AIR CONDITIONING IS RULED OUT- THEN CEILING FANS SHOULD BE INSTALLED IN THE INTERIOR HALLWAY AT LEAST EACH 12 FEET TO PROVIDE SOME MEANS OF AIR MOVEMENT TO HELP DRY FLOORS AFTER WASH DOWN AND PROVIDE IMPROVED VENTILATION DURING HOT