Laserfiche WebLink
Side Window <br />There shall be a fixed window approximately 18" X 36" installed above the squad bench. It shall be bronze <br />tinted safety glass. The window opening shall be framed with extruded aluminum tubing as part of the module <br />construction. <br />There shall be a sliding privacy cover over the window on the inside of the module. The surface of the cover is <br />to be of a material allowing use as a marker board. <br />Does your bid comply? Yes _X_ No <br />Door Construction <br />All module entry and compartment doors to be a minimum of 2 inches thick and fabricated in the following <br />manner: <br />(A). Exterior door skin shall consist of a single .125" aluminum sheet that is machine cut and formed to <br />provide a smooth and unbroken finish. The door shall include a full perimeter internal extrusion designed to <br />create a solid, square support structure for each door. Door extrusions will be mitered at each corner, fitted <br />with an extruded, saw- toothed key seat specifically designed to insert into the door extrusion. The corners are <br />then welded to promote a square fit and to prevent frame member separation. The doors will be interval <br />welded around the inside seam of the formed door skin and the extruded internal support. Doors that are <br />purely pan- formed without extrusions will not be considered. <br />(B). The doorjamb will consist of a custom exterior extrusion with an alloy rating of 6061 -T6. The doorjamb <br />extrusions will be mitered at each corner and welded to promote a square fit and to prevent frame member <br />separation. They will also be fitted with an extruded, saw- toothed key seat specifically designed to insert into <br />the door extrusion. The doorjamb will be attached to the body door framing with 3M -VHB tape and interval <br />welded around the full perimeter of the door opening. The joint between the doorjamb and the body side skin <br />shall be thoroughly seam sealed to provide a smooth unbroken finish and to prevent contamination, oxidation <br />and corrosion. Bolting or screwing the casing to body is not acceptable. <br />(C). The exterior door skin panel shall be .125" thickness, 5052 -H32 alloy rated aluminum, with the formed <br />corners welded and finished to provide a smooth, unbroken appearance. <br />(D). All doors to be reinforced with extruded internal braces bonded to skin surfaces. <br />(E). All doors are to be flush with their adjacent extruded doorjambs. <br />43 <br />Attachment number 1 <br />F -2 Page 91 <br />