AG 2012 02 20 - Laserfiche WebLink

Home Browse Search

2.5 GVWR The gross vehicle weight rating shall be 14,200 lb. Does your bid comply? Yes /No 2.6 Axles and Suspension The chassis provided shall be a 159 wheelbase, Heavy -duty front and rear springs with front stabilizer bar. Shock absorbers shall be heavy -duty. Front axle shall be rated at 4600 -1b. capacity with the rear axle at 9600 -lb. rated capacity. Rear wheels to be dual. Does your bid comply? Yes__,/No 2.7 Drive Shaft Guard The drive shaft shall be provided with a guard constructed of minimum 7 -gauge steel. The guard shall be positioned to prevent the front end of the drive shaft from contacting the ground and cause a catapulting effect in the event of a complete universal joint failure. Does your bid comply? Yes � No 2.8 Electrical The vehicle shall be supplied with three (3) 12 -volt batteries. They shall be standard OEM Heavy Duty Batteries with total capacity of 2250 CCA. All three batteries shall be mounted on a heavy -duty, slide -out tray in a sealed area below the ALS cabinet. A "jump start" plug shall be installed in the front bumper for ease of jump starting the vehicle should it be necessary. A 25' cable with the male : jump start" end on one side and positive and negative battery clips on the other shall be shipped loose with the vehicle. Does your bid comply? Yes No 2.9 Electrical Generating System: The ambulance shall be equipped with Chevrolet's YF2 Ambulance Prep Alternator Package. Does your bid comply? Yes No 2.10 Engine Engine size shall be a Duramax 6.6- Turbo - charged Diesel V -8 engine. Does your bid comply? Yes / No 2.11 Engine Block Heater The chassis shall have an OEM engine block heater. This heater shall be wired so that the end user has the option to directly connect the heater to the 110V shoreline input on the modular body. Also have option of disconnecting during summer months. / No Does your bid comply? Yes 2.12 Engine High -Idle Speed Control, Automatic Chassis shall equipment with an OEM High Idle System Does your bid comply? Yes No 2.13 Exhaust System The exhaust system shall be the OEM manufacturer's standard. There shall be galvanized heat shields above the exhaust system in accordance with Ford's QVM. The heat shields must be a minimum of 16 -gauge material for additional strength to prevent rattling. Exhaust pipe must have 1" clearance from rub rail and come out as close as possible to rear tire to prevent damaging tail pipe and hose from hanging. A Plymovent adapter shall be included and install d. Does your bid comply? Yes V No 9 Attachment number 1 F -5 Page 106