AG 2012 02 20 - Laserfiche WebLink

Home Browse Search

Two (2) 900 Series LED — Left Side - RED ® Rear Module Upper and Midline Two (2) 900 Series LED — Upper Corners - RED Two (2) 900 Series LED - Mid line to flash through the rear windows, if rear door(s) are in the open position - RED One (1) 900 Series LED — Upper Center, above rear doors. Also, said light wired into the brake lights to flash when the brakes are applied in non emergency mode. — AMBER These lights shall function in a dual mode system as shown in KKK- A -1822E and meet the physical and photometric requirements of that same document. Doors, auxiliary lights, or siren(s) shall not obstruct these warning lights. The red Whelen 500 Series LED "Grille" lights shall be located at least 30 inches above the ground, below the bottom edge of the windshield and will be laterally separated by at least 18 inches, measured from centerline to centerline of each lamp. Install a Code 3 "711" Wig Wag System to the Chassis head lights, as prescribed by Federal Spec KKKA 1822E. There shall be four (4) Grille lights, Two (2) Red and two (2) Clear. The red /clear Whelen 700 Series LED "intersection" lights shall be mounted on the front fenders of the chassis as far forward as possible. In addition, there shall be two (2) 700 Series Red LEDs mounted above each rear wheel well. These lights also include chrome bezels. All warning lights furnished shall be mounted to project their highest effective intensity beams on the horizontal axis. A Whelen AF6016 power supply will be provided. Does your bid comply? Yes No 4.4 Tail Lights The taillights on this unit will be Whelen LED 600 Series. Taillights will consist of brake -tail, turn and back -up lights. They shall include t e INTERIOR reareheadlknocker, `S ola maninform Tu Signals and Brake Lights mou nted on the attendants as to the driver's intensions. Does your bid comply? Yes No 4.5 Ha rdware, Construction, Switching A The emergency lighting system shall be comprised of components and devices that comply with the general requirements and tests of SAE J575g, J576d, and J551. Warning lights shall be firmly fastened to reinforced body surfaces. All connectors and wiring shall be rated to carry a minimum of 125% of their maximum ampere load. Does your bid comply? Yes ✓ No All emergency light switches shall be labeled as specified in KKK- A- 1822E, and the PRIMARY /SECONDARY mode switch shall have an indicator light to show the driver when primary mode is activated. All warning light t hes shall switches wired be located in the driver's to prov de the control console. The emergency light sw warning light signal modes and combinations as specified in K- 822E. Yes 1 O No Does your b id comply? 4.6 Scene and Loading Lights (Exte Scene and loading lights shall be not less than 75 inches above the ground and unobstructed by open doors. There will be four (4) Whelen 900 Series Halogen scene lights located one (2) on the left and two (2) on the right side of the ambulance body. They between will be firmly emergency t lightst o The reinforced body surfaces below the ro two (2) rear load lights shall be Whelen 900 Series load lights. Switches for both the scene and load lights shall be located on the front switch control panel. Rear load lights shall illuminate the Attachment number 1 F -5 Page 116